Welcome Guest [Log In] [Register]
Welcome to Rcsnowcats. We hope you enjoy your visit.

Join our community

Username:   Password:
Add Reply
Sabertooth problems
Topic Started: Mar 26 2012, 02:50 AM (422 Views)
blowout
Member Avatar

So I have had the Sabertooth in the SR since dang near the day I bought it. I have noticed recently that it has been glitching a lot. Normally it just did it when the battery was getting low, I use Ni-Mh Batteries. I can put a fresh batt in and if I give it the beans it will jump, The red led on the sabertooth will come on and the status "two" led will come on. Has anyone else had any issues like this. Also I have went over the dip switches a few times to make sure nothing changed and they are set up the same way I set them when I got them.
Offline Profile Quote Post Profile
 
phatchantz
Member Avatar
seƱor member
when mine gives me trouble, usually a "re-bind" will put it back to normal - has worked many times for me......
Offline Profile Quote Post Profile
 
Capt'n Cook
Member Avatar
Wish you were here...
I put mine in about 3 months ago... but since there has been absolutely no snow...well lets say it's just like new, works just like when I installed it.
Apologies...I'm not helping any.
Theres a mode with the 2 end switches to teach the endpoints of the throttle. Have you tried setting that?
Offline Profile Quote Post Profile
 
blowout
Member Avatar

Ok I know it has been awhile but I was talking to some other RC guys today out at the track and for the glitching problem I was told to put a Capacitor on the receiver but I have no idea on what size to put on there. Would anyone be able to tell me that?
Offline Profile Quote Post Profile
 
1 user reading this topic (1 Guest and 0 Anonymous)
« Previous Topic · Electronics · Next Topic »
Add Reply